-
Planner Basic Timing:
Planner Basic now works in fixed 30-minute slots. If you pause Planner Basic, it stops right away and will only start again at the beginning of the next slot, as long as no other heating mode is active.
-
Instant Heating Priority:
If you start Instant Heating, it begins immediately—even during a Planner Basic slot—and Planner Basic will stay paused until midnight.
-
Temperature Display:
The control screen always shows the current water temperature, even when heating is off. When heating is active, the current temperature is shown, and the “Start Heating” button is disabled if your target temperature is already reached.
-
Low/High Mode Control:
You can now switch between Low and High Mode directly from the Cost Control screen.
-
Instant Heating Restrictions:
While Instant Heating is running, you can’t change the temperature. To adjust it, first stop heating—then the plus (+) and minus (–) buttons will be available again.
-
No Cooling Mode:
You can no longer set a target temperature below the current water temperature, so the system will not enter cooling mode.
-
Pop-up Messages:
Only the information pop-up for High Mode will be shown. Pop-ups for Low Mode are now disabled to reduce interruptions.
-
Seamless Mode Switching:
Switching from Planner Basic to Instant Heating starts Instant Heating right away. If you stop Instant Heating and Planner Basic is enabled, Planner Basic will look for the next available slot (for example, if you stop at 2:32, it will start at 4:00).
-
Simplified Temperature Handling:
Minimum and maximum temperature values are no longer displayed, to avoid confusion. If you reach the maximum allowed temperature, you’ll see a clear message prompting you to switch heating mode to go higher.
-
Long Press Animation:
A new animation and message now appear to let you know when you need to hold a button for 3 seconds.